H3C 交换机配置WEB管理

By | 2018-11-27

实验环境: H3C S3600  + 原装CONSOLE线

用“超级终端”登录到S3600,不用密码

<H3C>system-view
[H3C]int vlan 1
[H3C]ip address 192.168.5.1 255.255.255.0        <– 配置IP地址为192.168.5.1 ,然后就可以用WEB登录了

登录需要用户名及密码

[H3C]sys

[H3C]local-user admin

[H3C]service-type telnet level 3

[H3C]password simple admin

[H3C]quit

————————  以下为H3C S3100V2 的配置手记  ———————–

配置步骤

(1)       配置Device

# 创建VLAN 999,用作远程登录,并将Device上与PC相连的接口Ethernet 1/0/1加入VLAN 999.

<Sysname> system-view

[Sysname] vlan 999

[Sysname-vlan999] port Ethernet 1/0/1

[Sysname-vlan999] quit

# 配置VLAN 999接口的IP地址为192.168.0.58,子网掩码为255.255.255.0

[Sysname] interface vlan-interface 999

[Sysname-VLAN-interface999] ip address 192.168.0.58 255.255.255.0

[Sysname-VLAN-interface999] quit

# 配置Web网管用户名为admin,认证口令为admin,用户级别为3级。

[Sysname] local-user admin

[Sysname-luser-admin] service-type telnet

[Sysname-luser-admin] authorization-attribute level 3

[Sysname-luser-admin] password simple xxxxx             <– “xxxxx”为密码

# 配置 Telnet

[Sysname] user-interface vty 0 4

[Sysname] authentication-mode scheme

[Sysname] user privilege level 3

[Sysname] quit

[Sysname] save

[Sysname] reboot

—————————————————————————————————————————

恢复出厂设置
[H3C]reset save
[H3C]reboot

_______________________________________________________________________

H3C S3100 重设web密码

1) system-view

2) local-user admin

3) password cipher 新密码

4) service-type telnet level 3

5) save

發佈回覆